telecaster seymour duncan wiring diagrams

#TELECASTER SEYMOUR DUNCAN WIRING DIAGRAMS FULL#

A Hot Rails in the bridge position will literally transform your Strat into a completely different instrument.

#TELECASTER SEYMOUR DUNCAN WIRING DIAGRAMS FULL#

Chords are full and powerful, and single notes jump out with amazing sizzle. The Hot Rails bridge model single coil ‘rails’ sized humbucker delivers high output, loads of midrange harmonics, and an aggressive crunch that makes this a great bridge pickup for rock and metal. The dual blade construction gives you the ultimate string coverage, especially for notes that are bent on the highest frets. Clean tones are fat and warm, and solos will have that thick, fluid feel. The Hot Rails neck model uses a strong ceramic magnet and overwound coils to deliver big sounding, well balanced humbucker tones for rock and metal. Output – The overall output of a passive pickup is influenced by several design factors: number of turns of wire on the coil(s), strength of the magnet, coil geometry and magnetic circuit geometry.The output of an active pickup is influenced by the same factors but is predominantly determined by the design of the onboard preamp.Įnd your quest for fire with the Hot Rails for Strat single coil sized humbuckers. Looking at this from another point of view, ceramic magnets can be said to produce increased clarity, better note definition and faster response to picking. It is for this reason that many consider ceramic magnets to have a brittle sound, not their gauss strength. This has the effect of decreasing the inductance of the pickup and significantly raising the resonant frequency. The magnets at the lower end of the scale tend to produce a softer attack and a degree of “bloom” to the envelope of the note.Ĭeramic magnets should be considered as an individual case because they do not contain any nickel or iron. As the gauss strength goes up, so does the output. From there in order of ascending strength you have A2, A4, A5, A6, Ceramic and A8. Of the magnets we use, Alnico 3 has the lowest gauss strength. In the case of pickups, the most significant characteristic is the gauss strength, which is a measure of the density of the magnetic field. Magnet – We use several different magnet formulations: Alnico 2, Alnico 3, Alnico 4, Alnico 5, Alnico 6, Alnico 8 and Ceramic 5/8. DCR is often used as a gauge of output because as the turns increase, so does the output, though magnet type and the coil geometry also influence output.

The length of the coil form, the number of turns and the gauge of wire all affect the DCR reading. DCR – Short for DC Resistance, is measured in Ohms and is the total resistance of the copper wire wound around a coil form.

Telecaster seymour duncan wiring diagrams